TCCoA Forums banner

PI Cam identification

1K views 2 replies 3 participants last post by  XR7-4.6 
#1 · (Edited)
Hello, I have not been on here in quite sometime but I was cleaning out my storage unit and came across some old parts that I was going to use when I had my 95 4.6L Thunderbird.

I found some cams that I was going to use for a PI head, Cam and Intake swap. However I am having difficulty finding a part number on the cams to verify they are actually PI Cams. Is there usually a part number stamped into the cams for identification purposes? If not, how would I be able to tell if they are PI or non PI cams?

I have a set of Non-PI head that the person who sold them to me swore up and down they were PI, but being young and dumb back then I believed him and got Non-PI heads. If I remember correctly, these cams did not come out of the Non-PI heads I have.

Attached are some picture of the cams.

Thanks!
 

Attachments

See less See more
3
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top